Description

In Milesight Gateway, LoRaWAN related features are divided into two sections, “Packet Forwarder” and “Network Server”. Both of them support changing LoRa frequency plan. After you change the LoRa frequency plan on either section and click Save & Apply, it will be also changed on the other one.

Frequency plan is changeable in each module only:

For 868 module: EU868, IN865, RU864

For 915 module: US915, AU915, KR920, AS923-1&2&3&4

This article will guide you how to change LoRa frequency plan in Milesight gateway.

Requirement

Milesight LoRaWAN Gateway UG6x or UG8x.

Configuration

1. Packet Forwarder

Go to Packet Forwarder ->Radios. Under Radio Channel Setting you can choose different channel plans in drop-down box where all supported frequencies are displayed in this gateway. After the frequency is chosen, the center frequency and frequency points would change to default values automatically and can be manually changed anytime.

Click Save & Apply.

Note: All package forwarder settings will be cleaned if you change the frequency.

2. Network Server

Go to Network Server-> General -> Channel Plan Setting. You can choose different channel plan in drop-down box where all supported frequencies are displayed in this gateway.

Channel mask works similarly as in the center frequency and frequency points, and is designed to only allow the enabled frequencies to work. To leave it blank means using the default standard usable channels specified in the LoRaWAN regional parameters document. 

Click Save & Apply.

Appendix

Default Frequency supported on Milesight Gateway. AS923-2&3&4 is only applied to UG6x.

--END--